#include "inc/hw_memmap.h"
#include "inc/hw_types.h"
#include "driverlib/gpio.h"
#include "driverlib/sysctl.h"

/* 寄存器地址 ---------------------------------------------------------------*/
#define GPIO_PORTF_APB_DIR_R 0x40025400
#define GPIO_PORTF_APB_DEN_R 0x4002551C

/* 用于調(diào)試 PF1 <-> LED -----------------------------------------------------*/
#define LED_PERIPH SYSCTL_PERIPH_GPIOF
#define LED_PORT GPIO_PORTF_BASE
#define LED_PIN GPIO_PIN_1
#define LED_OFF 1 << 1
#define LED_ON ~(1 << 1) // 低電平點(diǎn)亮LED

void Delay(volatile signed long nCount)
{
for(; nCount != 0; nCount--);
}


long test;
long clk;

int main(void)
{
// Set the clocking to run directly from the crystal.
/*SysCtlClockSet(SYSCTL_SYSDIV_1 | SYSCTL_USE_OSC | SYSCTL_OSC_MAIN | SYSCTL_XTAL_16MHZ);
clk = SysCtlClockGet();

// LED------------------------------------------------------------------------------
SysCtlPeripheralEnable(LED_PERIPH); // 使能LED所在的GPIO端口
GPIOPinTypeGPIOOutput(LED_PORT, LED_PIN); // 設(shè)置LED所在管腳為輸出

while (1)
{
GPIOPinWrite(LED_PORT, LED_PIN, LED_ON); //點(diǎn)亮LED
Delay(0xfffff);
GPIOPinWrite(LED_PORT, LED_PIN, LED_OFF); //熄滅LED
Delay(0xfffff);
}*/


// Set the clocking to run directly from the crystal.
SysCtlClockSet(SYSCTL_SYSDIV_1 | SYSCTL_USE_OSC | SYSCTL_OSC_MAIN | SYSCTL_XTAL_16MHZ);

// Key------------------------------------------------------------------------------
SysCtlPeripheralEnable(SYSCTL_PERIPH_GPIOJ); // 使能GPIOJ端口
GPIOPinTypeGPIOInput(GPIO_PORTJ_BASE, GPIO_PIN_7);
GPIOPadConfigSet(GPIO_PORTJ_BASE, GPIO_PIN_7, GPIO_STRENGTH_2MA, GPIO_PIN_TYPE_STD_WPU);

while (1)
{
if (test = GPIOPinRead(GPIO_PORTJ_BASE, GPIO_PIN_7))
{
Delay(0xfffff);
}
}
}